Wish List 0

Atmega 2560 R3 With A To B Cable 30 Cm For Arduino Mega 2560 Atmega16U2 Usb

Rs. 1,191.00 Rs. 1,358.00

DESCRIPTION
-The Mega 2560 Atmega2560-16au compatible with Arduino is a micro-controller board based on the ATmega2560. It has a USB host interface to connect with Android based phones, base on the MAX3421e IC.
-It has 54 digital input/output pins (of which 15 can be used as PWM outputs); 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator; a USB connection, a power jack, an ICSP header, and a reset button.
-The MEGA ADK is base on the Mega 2560. Similar to the Mega 2560 and Uno, it features an ATmega8U2 program as a USB-to-serial converter.
-Revision 3 of the Mega ADK board has a resistor pulling the 8U2 HWB line to ground, making it easier to put into DFU(Device Firmware Upgrade) mode.

The board has the following new features:
-1.0 pin-out: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board. In the future, shields will be compatible both with the board that uses the AVR, which operate with 5V and with the Arduino Due that operates with 3.3V.
-The second one is a not connected pin, that is reserved for future purposes.

Stronger RESET circuit.
-The Mega Arduino R3 Android Accessory Development Kit (ADK) can be power via the USB connection or with an external power supply. The power source is select automatically. External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board’s power jack.
-Leads from a battery can be inserted in the GND and Vin pin headers of the POWER connector.
 Because the Mega R3 Android Accessory Development Kit (ADK) is a USB Host, the phone will attempt to draw power from it when it needs to charge.
 When the ADK is power over USB, 500mA total is available for the phone and board.
SPECIFICATION
Analog I/O Pins 16
Clock Speed 16 MHz crystal clock.
Digital I/O Pins 54 digital input/output terminals
Flash Memory 256 KB of which 8 KB used by boot-loader.
Input Voltage(Recommended)  7V – 12V
Microcontroller ATmega2560
Operating Voltage 6~12V
PWM Output Pins 14

OVERVIEW:

-Programmer: Atmel

-ATmega2560 microcontroller.

-54 digital input/output terminals (14 of which have programmable PWM outputs).

-16 analog inputs.

-4 UARTs (hardware serial ports).

-16 MHz crystal clock.

PACKAGE INCLUDES:

1 PCS x Atmega 2560 R3 With A To B Cable 30 Cm For Arduino Mega 2560 Atmega16U2 Usb Ic

1 PCS x Cable for Mega 2560

15 Days

Write a review

Please login or register to review