Arduino Nano Ch340 Chip Board With Usb Cable A To Mini Compatible With Arduino

-The CH340 Soldered Nano Board R3 Chip without USB Cable chipboard is based on the famous Arduino platform and does all the functions of Uno, but with a smaller footprint.

-Nano CH340 Soldered Board R3 Chip without USB cable is vital for your small project where you don’t need much of a pin-outs but the small size is very important to make it look good.

-The Nano equips a low-cost USB-Serial Chip that makes it less in price than Nano with FTDI USB-Serial Chip used on older versions of Arduino Nano.

-The Nano is a small, complete, and breadboard-friendly board based on the ATmega328 (Arduino Nano R3). It has more or less the same functionality of the Arduino Uno but in a different package. It lacks only a DC power jack and works with a Mini-B USB cable instead of a standard one.

-The Nano can be power via the mini-USB connection, 6-20V unregulated external power supply (pin 30), or 5V regulated external power supply (pin 27). The power source is automatically selected to the highest voltage source.

-it comes with 6 PWM I/O from the total of 14 digitals I/O, 8 analog inputs, 16Mhz clock speed and 32kB of flash memory.

Note:

CH340 chip might not work directly with some PC/Laptop, you will need some ch340 drivers.

Features:

-1 pair of TTL level serial transceiver ports RX / TX

-Using Atmel Atmega328P-AU MCU

-There is a bootloader installed in it

-Support USB download and Power

-Support for external 5V ~ 12V DC power supply

-Support power supply by 9V battery

-Support ISP download

-Automatic reset during program download.

-Power OK blue LED on the bottom.

-Green (TX), red (RX) and orange (L) LED.

-+5V to AREF jumper.

-Auto sensing/switching power input.

-Small mini-B USB for programming and serial monitor (cable not included).

-ICSP header for direct program download.

-Standard 0.1” spacing DIP (breadboard friendly).

-Manual reset switch.