Ant801S Vibration Shock Sensor
Rs. 153.00 Rs. 184.00
- Product Code: SEN-VIB
- SKU -
- Availability: In Stock
- Price in reward points: 1
- For Bulk Order
9962060070
Quick support on WhatsApp (+919962060070) only between morning 11am-4pm, no call will be answered
| SPECIFICATIONS: | |
| IC Chip | LM393 |
| Operating Voltage(VDC) | 3 to 5 |
| PCB Size (mm) | 35×12 |
| Height (mm) | 9 |
| Shipment Dimensions | 5 × 3 × 3 cm |
OVERVIEW:
-Has a signal output instruction
-When the output valid signal is high, the light goes out
-The sensitivity is adjustable (fine-tuning)
-The wide detection range of vibration, no direction
-With mounting holes, firmware installation is flexible and convenient.
PACKAGE INCLUDES:
1 PCS x 801S Vibration Shock Sensor
//SOURCE CODE TAKEN FROM BELOW LINK
//https://electropeak.com/learn/interfacing-801s-vibration-sensor-module-with-arduino/
/*
Button
Turns on and off a light emitting diode(LED) connected to digital pin 13,
when pressing a pushbutton attached to pin 2.
The circuit:
- LED attached from pin 13 to ground
- pushbutton attached to pin 2 from +5V
- 10K resistor attached to pin 2 from ground
- Note: on most Arduinos there is already an LED on the board
attached to pin 13.
created 2005
by DojoDave <http://www.0j0.org>
modified 30 Aug 2011
by Tom Igoe
This example code is in the public domain.
http://www.arduino.cc/en/Tutorial/Button
*/
// constants won't change. They're used here to set pin numbers:
const int buttonPin = 2; // the number of the pushbutton pin
const int ledPin = 13; // the number of the LED pin
// variables will change:
int buttonState = 0; // variable for reading the pushbutton status
void setup() {
// initialize the LED pin as an output:
pinMode(ledPin, OUTPUT);
// initialize the pushbutton pin as an input:
pinMode(buttonPin, INPUT);
}
void loop() {
// read the state of the pushbutton value:
buttonState = digitalRead(buttonPin);
// check if the pushbutton is pressed. If it is, the buttonState is HIGH:
if (buttonState == HIGH) {
// turn LED on:
digitalWrite(ledPin, HIGH);
} else {
// turn LED off:
digitalWrite(ledPin, LOW);
}
void loop() { Serial.println("0");}
15 days