CALL US : +919962060070


Price :
Quantity :  
  • 100 Units in Stock





Flame module Interface module and number 13 comes with LED build a simple circuit to produce flame warning lamp 13 comes with digital interfaces of the LED, the flame sensor connected digital three interfaces, when the flame sensor senses There are key signal detected, LED lights, otherwise off.
Sensor for flame wavelengths between 760 nm to 1100 nm infrared is most sensitive 60 degree detection sensor Two outputs mode: AO: analog output- real-time output voltage signal on the thermal resistance DO: when the temperature reaches a certain threshold- the output high and low signal threshold adjustable via potentiometer

The Grove - Flame Sensor can be used to detect fire source or other light sources of the wavelength in the range of 760nm - 1100 nm. It is based on the YG1006 sensor which is a high speed and high sensitive NPN silicon phototransistor. Due to its black epoxy, the sensor is sensitive to infrared radiation. In fire fighting robot game, the sensor plays a very important role, it can be used as a robot eyes to find the fire source.


 • Detects a flame or a light source of a wavelength in the range of 760nm-1100 nm

 • Detection distance: 20cm (4.8V) ~ 100cm (1V)

 • Detection angle about 60 degrees, it is sensitive to the flame spectrum.

• Comparator chip LM393 makes module readings stable.

 • Adjustable detection range. • Operating voltage 3.3V-5V

 • Digital and Analog Output DO digital switch outputs (0 and 1) AO analog voltage output

• Power indicator and digital switch output indicator

§  Grove Interface

§  High Photo Sensitivity

§  Fast Response Time

§  Easy to use

§  Sensitivity can adjustable

Application :

·         The module is mainly used to detect the infrared light.

·          It outputs digital signal 0 and 1 through a Comparator output.

·         The output value will be 0?? when infrared light is detected.

·          And the sensitivity is adjustable by the precision potentiometer.


·         VCC...... Positive voltage input: 5v for analog 3.3v for Digital.

·         A0.......... Analog output

·         D0......... Digital output

·         GND..... Ground


1.18 in x 0.59 in x 0.20 in (3.0 cm x 1.5 cm x 0.5 cm)


0.28 oz (8 g)