CALL US : +919962060070


Price :
Quantity :  
  • 99 Units in Stock



A simple Flex Sensor is 2.2" in length. As the sensor is flexed, the resistance across the sensor increases.  The resistance of the flex sensor changes when the metal pads are on the outside of the bend (text on inside of bend ). Connector is 0.1" spaced and bread board friendly. The value of the output depends on the bending of the sensor hence, the output we get is an analog value and this output can be send to ADC IC or of Controller.

Working and Modifications
-    The Bending and resistance value are directly related to each other as  :
                o    Flat (nominal resistance)
                o    45 degree Bend (increased resistance)
                o    90 degree Bend (resistance increased further)
-    An Op - Amp is used and outputs either high or low depending on the voltage of the inverting input.
     In this way you can use the flex sensor as a switch without going through a microcontroller.
-    A potentiometer can be added to the circuit to adjust the sensitivity range.
-    Use the sensor as the input of a resistance to voltage converter using a dual
     sided supply Op - Amp. A negative reference voltage will give a positive output.
     Should be used in situations when you want output at a low degree of bending.


Please refrain from flexing or straining this sensor at the base. The usable range of the sensor can be flexed without a problem, but care should be taken to minimize flexing outside of the usable range. For best results, securely mount the base and bottom portion and only allow the actual flex sensor to flex.